Looking like something.
Second layer 4mm going on topside.
Fine entry
Second topside being templated.
Fairly ‘flarey’
Second topside on
Shapely
Side view.
Bottom forward section templates on.
Second topside on.
A little flare.
One layer on one topside.
Rear of hull sheathed in 9mm ply. Cut from 3mm MDF templates. Same for the chine sheathing. First layer of 4mm spliced onto the 9mm rear section...
Figured out how far forward I could get with 9mm before the curves got too much, then shaped a 150mm splice on the forward edge.
Epoxy arrived.