Ok, thanks for the input. I am hoping it is still ok and I will open it up and have a look, seal replacement in hand. It ran smoothly before I...
Hi everyone. Some time ago I posted questions about my engine renovation and particularly about sand blasting engine parts. It's going well and I...
For anyone who might have the same problem: I managed to take the thing apart by lifting off the snap ring from the square inner hub. And rubber...
Well, I was just wandering whether Hammerite is a good product for the steel engine parts, or if I should look around for something else. Also, in...
Ah, I did not know that threads had to be closed. As far as I'm concerned it is now an issue about handelling the part.
Yes, C. Dog, it will cost little to dissasemble and ascertain. Only I need to know how. Hence the question about experience. Buying a new one is...
Everybody here in Sweden seem to go for, and recommend, Hammerite. They promise "no primer needed", which allways makes me suspicious. Any opinions?
I have just managed to get the damper plate off of the flywheel on my penta md2010, but unfortunately it is in a bad state. The steel parts have...
Stop all your worries! No more lost sleep over my problem. The flex plate popped out today, after some more knocking. It is however in a bad state...
Thank you Gonzo! My intuition was right then. And how about that advice to scorch the parts with a blow torch to bring out impurities to the...
I am taking apart a Volvo MD2010 from 2006 that has been damaged by salt water. See my other post about issues removing the driveplate in the...
Thank you for your replies. I have now concluded that mine is the newer version of flex plate, which is built rather like a sandwich with one...
