In my opinion if a river is shallow enough to to warrant jet drives the ATV can just drive trough it. Anyway, I don't see why he can't have both,...
"From deck to bulwark" isn't a phrase that makes sense because the bulwark is an extension of the topside, so that distance is usually zero, with...
Actually we don't know how old his engines are, there is a slight discrepancy in the description, 1990 there was no 220hp Volvo Penta diesel....
We will join your wondering because getting details is like pulling teeth. Nevertheless we can offer scenarios: 1. Boat has period 200hp Volvo...
Repair the non runner or replace it with a used one of the same make and model. This way you have redundancy and maneuverability, and more...
Of course it's possible but why bother? Two 100hp engines are going to have worse fuel economy then one 220hp engine so the obvious answer is to...
What exactly does "high speed" mean? These outboards run 5000rpm engines, so unless you plan to run the electric motor at a constant 10,000 rpm...
Researching the originals will not bring you much for your project. The windward performance of a long and shallow full keel just isn't very good....
I would probably use a laminate trimmer (small router) with a jig clamped in place. Also clamp or hot glue a backing board on the other face of...
Ok, I had a good laugh, now it's time for something more serious. Building and operating such a vehicle in the EU on public roads is a serious...
I would say that is most certainly not Beneteau's work. The first layer behind the gelcoat would have been mat, and it's impossible to remove that...
If you want to use two molds you must first decide how to join the two halfs of the boat (hull and deck). On the photo you posted of the Liteboat...
What's the problem gonzo, the weight comes with a corresponding area, it's exactly the same as any flat bottom barge. A 14'x70' single wide needs...
If you ask someone for money for this project sooner or later they are going to ask the hard question: How are you going to beat the autonomous...
Template the missing corner, add allowance for a 8:1 scarf, cut the scarf on repair piece and existing bulkhead and glue in with thickened epoxy....