Back in the day, I was coxswain for Coast Guard Monomoy lifeboats. The Monomoy does not resemble the pictures here, in the slightest. It is a...
Give some more thought to the sail rig. A gaff rig is suitable for sailing but is not as convenient as a sprit sail or lug sail. Why would...
It would be good to make some educated guesses about the two wakes between the hulls. At some speed the wakes crash together when the boat is...
Whether buttocks, diagonals, or water lines, the general idea is to minimize acceleration and deceleration of a unit of mass as in a water...
The S-H participants may need to see a competent therapist. Year after year there are broken boats and broken bones as a result of vicious...
The type was often called Port Ritchey Skiff , in Florida, back in the day. As Gonzo has noted, there was no formal design, the builder used...
I cannot be certain that I understand the reason for doing the modification. If you use a 20 shaft outboard on a 16 inch transom, there will be...
You have shown some particularly "fat" boats. If you wish to concentrate only on boats to operate in brisk or brutal winds, then the wide ones...
Take a look at the Goat Island Skiff. It is a simple build, with good performance. The design is straight forward and you can use the GIF among...
a model outboard motor will satisfy the need for horizontal shaft and distance above or below the bottom of the boat. If your budget can manage,...
Towing a trailer with a manual or electric bike is comm9n practice. Near my house is a walking or biking, paved, trail. I see more than a few...
Both these boats are designed as planing boats. When not driven fast enough to plane, the transom will be dragging a bunch of water. That saps...
150 pounds is a bit much for a ten foot Jon boat. If 49 inches acro9ss the bottom, it will need a lot of frames and stringers. It might be made...
Not a mistake Bluebell. The number 75 did appear elsewhere in the replies. Prop center 13.7 mm above the bottom is a puzzling requirement....
the original post says that is to be 45 mm.
