Talking to you. Just a less than quiet observation.
The one view of your boat really makes it look like the cav plate is misaligned with the hull bottom which would result in lifting the bow. It is...
I purchased two Maretron fuel senders with float tubes. I still have to determine the line distances and see if I have any n2K cables long...
Clearly a major problem here as the hulls cannot be moved in their current state. The project did not make it to critical mass.
@Tonja Jiran please check your email and junk email I am sending you a private message.. Dan Fall
He corrected the issue by removing fixed trim tabs. If the boat cannot get the bow up high enough to get to aft planing surfaces; it’ll tip and...
If you bush them, that will help. The issue wth the bolts is they are not rated for misuse. They may have enough tensile strength to carry the...
Well, predrilling for pine and oak would generally be different. I’d want to drill the oak at just above the minor or at it and the pine can be...
Epoxy, my first thought when you said lead anchor.. Isn’t your pof the bolt holding the turdbuckle to the mount? Serious question, I apologize....
Is that macerated waste? Which tank is which and why is one round? Guessing that is graywater, but maybe the shape is important for b/w? Or for...
If you decide glass is required, csm is far better choice than woven. And I’ve used it with epoxy. The way to do it is take a piece of clear...
1. Remove all the loose stuff or any fibers not in original matrix. 2. Grind a 12:1 taper into the existing core on the outside. 3. Cut the...
Maybe I will tip the fill end up a bit?
you shared a map..where are we going
I can also run a copper wire into my main ground system. Any advantage one to another?
